Reply to Xone k2 and Traktor LED Issues

Recently purchased two Xone k2s, one being used for my Traktor Machine. While I have the setup pretty much the way I want, I am now working on LED output for feedback.

Anyways, with more research I believe ive figured out how to do what I am seeking in two different ways (One requires I use modifiers)

But Both are not functioning correctly at this point for some reason.

For my FX selector, I have a button that cycles through the available FX i have activated (3 in my case).. So now I am trying to set an ouput with

Effect 1 Selector -> Note(red) g#1 -> Controller Range: 1 - 1 Invert Blend Off

Effect 1 Selector -> Note(orange) g#4 -> Controller Range: 2 - 2 Invert Blend Off

Effect 1 Selector -> Note(Green) g#7 -> Controller Range: 3 - 3 Invert Blend Off


LED is off on no effect, then it cycles to red, then to orange, but turns off again and doesnt set the led green. It cycles back to no effect, then goes on again for red orange etc..

For my efffect knob selector, I have a button that switches between knob 1 and 2 on the effect, this is affected by using modifiers to tell the encoder what effect knob to change.

My goal was to change the color between Red and ORange based on which knob it was changing.

I attempted this by

Modifier 4 Out -> m4 = 0 -> Red Note -> Controller Range 0 0
Modifier 4 Out -> m4 = 1 -> Orange Note -> Controller Range 1 1

LEd glows red, push button light turns orange, and remains orange and wont go back to red... Ive also tried just leaving the controller range alone at 0 7... and 0 1


Any ideas or help is appreciated! Thanks