S4 Filter Knob Stopped Working After DJTT Mapping! Help!
S4 Filter Knob Stopped Working After DJTT Mapping! Help! Posted on: 09.10.2013 by Jenna Elderkin Hey!Like the title says my filter knob stopped working after importing the DJTT S4 Custom Mapping. It was working for a bit then I couldn't get it to work for any of the channels. Help me out! Thanks, Eddie | |
| Jenna Elderkin 09.10.2013 | Hey! Like the title says my filter knob stopped working after importing the DJTT S4 Custom Mapping. It was working for a bit then I couldn't get it to work for any of the channels. Help me out! Thanks, Eddie |
| Tera Baragan 10.10.2013 | Just a thought, If you have 2 mappings for the same controller loaded into the controller manager it sometimes would glitch out on me like that. Filter wouldn't work sometimes, sometimes my looper wouldn't work etc. |
| Kellie Myrum 09.10.2013 | Some mapping commands can stop responding when you do a lot modifiers (talking about thousands of entries in a single device). .... Try adding new Filter Adjust commands and assign each to corresponding deck. You can delete old command if you want, but you can also leave it there and not worrying about since Traktor always make new duplicated command valid. If this won't do make sure those knobs send signal at all. |
| Charline Dye 09.10.2013 | Ah hah, read the directions and all will be revealed. |
| Lakeesha Storman 09.10.2013 | I believe you have to press Shift+Gain to get the filter to work, otherwise it takes on some other functionality. There are some comments under the mapping stating how to get filter working again. |
| Charline Dye 09.10.2013 | Have you tried reimporting the mapping and settings? A lot of maps require that you import twice. And make sure you follow the install instructions for the mapping to the letter. |
<< Back to General DiscussionReply