Send Monitor State Command in Traktor - Causes minor crack / pop when triggered
Home :: General Discussion :: Send Monitor State Command in Traktor - Causes minor crack / pop when triggeredReply
Send Monitor State Command in Traktor - Causes minor crack / pop when triggered Posted on: 17.06.2012 by Cliff Lohman Hi,I use send monitor state when changing deck focus for certain things (mainly to get the sync led + hotcue leds to update on my SC3900 as I use it to control multiple decks <one at a time>). However, I get a single small audio crack when I trigger it. Any ideas on how to clear this up? Is this a common problem? Thnx! | |
| Cliff Lohman 17.06.2012 | Hi, I use send monitor state when changing deck focus for certain things (mainly to get the sync led + hotcue leds to update on my SC3900 as I use it to control multiple decks <one at a time>). However, I get a single small audio crack when I trigger it. Any ideas on how to clear this up? Is this a common problem? Thnx! |
| Cliff Lohman 18.06.2012 | Found a tip that said to use a modifier to get traktor to update leds. So i deleted all the send monitor state commands and replaced them with a dummy modifier that just increases its value when i press certain shift-page type buttons. This seems to update my leds and doesnt cause audio glitch |
<< Back to General DiscussionReply