Recording audio volume is too low.
Recording audio volume is too low. Posted on: 24.10.2013 by Devora Chait Hey all, so I have 2 cdj's and a mixer which is hooked up to KRK 8's and the 10s sub, the mixer is a DJM 200 and I have the master 2 going to an external USB sound card, here is the thing, it seems like my master level is extremely low, I have to crank up the volume so much that I would have to blow up my room to get a proper signal to send to my laptop for recording. The signals coming from the CDJ's are fine, but the master on my mixer is just barely flashing 2 green led's on the meter (whatever it's called...) Right now I have the line in dialed up all the way on the sound card and the signal is just barely coming in, and there is an annoying white noise underneath it. Does anyone know what could be the problem here? I'm using an audio track in ableton to record. | |
| Devora Chait 24.10.2013 |
Originally Posted by keithace
PS: Sorry to sound stupid but booth out? My mixer has 2 master outputs (the red/white cable forgot the english name for them), this what you mean by booth out? |
| Devora Chait 23.10.2013 |
Originally Posted by Eliot Han
|
| Devora Chait 24.10.2013 | Hey all, so I have 2 cdj's and a mixer which is hooked up to KRK 8's and the 10s sub, the mixer is a DJM 200 and I have the master 2 going to an external USB sound card, here is the thing, it seems like my master level is extremely low, I have to crank up the volume so much that I would have to blow up my room to get a proper signal to send to my laptop for recording. The signals coming from the CDJ's are fine, but the master on my mixer is just barely flashing 2 green led's on the meter (whatever it's called...) Right now I have the line in dialed up all the way on the sound card and the signal is just barely coming in, and there is an annoying white noise underneath it. Does anyone know what could be the problem here? I'm using an audio track in ableton to record. |
| Alphonso Deitchman 25.10.2013 | Pioneer mixers are designed to run with peaks in the orange (for both Channels and the Master). If you're only getting a few bars of green, your outputs will of course be very low. |
| Layne Koop 24.10.2013 | It is possible that the "Master 2" output is lower output than "Master 1". Try swapping the speakers & recording cables on the Master 1 & 2 outputs. This test will show if there is a substantial difference in the output levels between Master 1 & Master 2. Also, on a typical computer, there are SEVERAL places to set the input gain for recording. Be sure that you have checked them all. In particular, check the OS level input and the Recording Software level input. There may also be a physical control on the soundcard...you don't mention the model so I can't look it up. |
| Devora Chait 24.10.2013 |
Originally Posted by keithace
PS: Sorry to sound stupid but booth out? My mixer has 2 master outputs (the red/white cable forgot the english name for them), this what you mean by booth out? |
| Latoria Kavulich 23.10.2013 | Booth out ftw. It can be tricky recording sometimes, when i record others using cdjs etc, i use audition through my audio 6, you need to find a good balance of volume and recording level. in your case as mentioned above, best bet is to get your main level up to 3/4 and go from there. Easy enough if you use traktor, other apps are a different story |
| Margie Pavell 23.10.2013 | it sounds like the problem is at the mixer. You said the master only gets up to few bars of green? Turn the gains up on the CDJs. How does the mixer sound through the headphones? Did Pioneer ever make a DJM 200? |
| Devora Chait 23.10.2013 |
Originally Posted by Eliot Han
|
| Halley Wurzer 23.10.2013 | This is where an AUX or Booth Out would really help you. When I record from my DJM-909, I have the master low as well (BX8 D2 Monitors) but adjust the Session Out to the proper level for recording (usually about 75%-80% up). |
| Ciara Cuttill 23.10.2013 | are you sure the input volume is set correctly in your audio settings menu? |
| Devora Chait 24.10.2013 | They are already turned way down that is kind of the issue. I can barely put my sub on over 3/10th of the volume or the bass is just crazy |
| Alphonso Deitchman 24.10.2013 | Turn your speakers down and your master level up. |
<< Back to General DiscussionReply