Mfpro calibration ?

Home :: MIDIfighter Resources and Discussion :: Mfpro calibration ?Reply
Mfpro calibration ?
Posted on: 24.11.2011 by Cliff Lohman
Hi, is there a way to calibrate mfpro knobs and faders either thru spftware or thru physical maintenance?

Surprisingly, i couldnt find one mention in the community about mf calibration..
Cliff Lohman
24.11.2011
Originally Posted by weltraumpapst
that sounds faulty.. shoot an email to orders@djranking s.com they'll figure something out..
shot them a message.. we'll see what they say.. its not that bad (probly sounds worse than it really is). Hopefully, i dont need to trouble them with a repair or anything like that.. it should probably be a minor adjustment
Cliff Lohman
24.11.2011
Originally Posted by weltraumpapst
why do you want to calibrate them? dont they work out of the box for you?
The filter knob and one of the faders are slightly off..

For example, if I hit the MIDI LEARN in traktor - without even touching the filter knob, it will sometimes trigger a note. And when I twist to middle, it sometimes will be + / - 2% on the filter instead of 0.

Same with the fader but the fader is barely noticeable - i did notice it send a note when i was midi mapping with the learn button in traktor.
Cliff Lohman
24.11.2011		Hi, is there a way to calibrate mfpro knobs and faders either thru spftware or thru physical maintenance?

Surprisingly, i couldnt find one mention in the community about mf calibration..
Arletha Hoage
28.11.2011		You may want to put a isolation diode in there.
Cliff Lohman
24.11.2011
Originally Posted by weltraumpapst
that sounds faulty.. shoot an email to orders@djranking s.com they'll figure something out..
shot them a message.. we'll see what they say.. its not that bad (probly sounds worse than it really is). Hopefully, i dont need to trouble them with a repair or anything like that.. it should probably be a minor adjustment
robin loo
24.11.2011		that sounds faulty.. shoot an email to orders@djranking s.com they'll figure something out..
Cliff Lohman
24.11.2011
Originally Posted by weltraumpapst
why do you want to calibrate them? dont they work out of the box for you?
The filter knob and one of the faders are slightly off..

For example, if I hit the MIDI LEARN in traktor - without even touching the filter knob, it will sometimes trigger a note. And when I twist to middle, it sometimes will be + / - 2% on the filter instead of 0.

Same with the fader but the fader is barely noticeable - i did notice it send a note when i was midi mapping with the learn button in traktor.
robin loo
24.11.2011		why do you want to calibrate them? dont they work out of the box for you?

<< Back to MIDIfighter Resources and DiscussionReply

Copyright 2012-2023
DJRANKINGS.ORG n.g.o.
Chuo-ku, Osaka, Japan

Created by Ajaxel CMS

Terms & Privacy