MF Stuck after 4 corner procedure
MF Stuck after 4 corner procedure Posted on: 26.12.2011 by Valarie Rossen Hi Guys, Unfortunately I ran into a problem with my beloved MF Classic. During a gig, while I was playing, the MF start to respond strange, I mean that when pressed the shift+"RED BUTTON" (deckalized mapping) buttons for example, to engage the hot cue mode, the led does not lit up as they should to indicate the mode, the same for the slicer mode, even if the mapping works, I can actually juggling with the cues and use the slicer, and ALL the led lights up when pressed. I tried to change mappings, reinstall Traktor 2, redownload mappings but nothing changed, so I tought to update the firmware. As first I tried with the old utility (MFUpdate), clicked on "Update Midifighter" and followed the 4corner buttons procedure but I received this message: and now the MF is stuck with all the led light up except for the third of the third row. How on heart could be? I tried to search in the thread already opened but I haven't found anything... PS I tried also with the new config utility but the app says "No midifighter connected" Please could you help me??? Thanks a lot guys! | |
| Valarie Rossen 26.12.2011 | Hi Guys, Unfortunately I ran into a problem with my beloved MF Classic. During a gig, while I was playing, the MF start to respond strange, I mean that when pressed the shift+"RED BUTTON" (deckalized mapping) buttons for example, to engage the hot cue mode, the led does not lit up as they should to indicate the mode, the same for the slicer mode, even if the mapping works, I can actually juggling with the cues and use the slicer, and ALL the led lights up when pressed. I tried to change mappings, reinstall Traktor 2, redownload mappings but nothing changed, so I tought to update the firmware. As first I tried with the old utility (MFUpdate), clicked on "Update Midifighter" and followed the 4corner buttons procedure but I received this message: and now the MF is stuck with all the led light up except for the third of the third row. How on heart could be? I tried to search in the thread already opened but I haven't found anything... PS I tried also with the new config utility but the app says "No midifighter connected" Please could you help me??? Thanks a lot guys! |
| Adolf Hit 18.01.2012 | Hi Esca, Your problem is that you ran the update app (the old one) from the dmg file it comes packaged in. You need to drag the program onto your desktop first. Try again - you will need to use the jumpers to access boot loader mode now. Remember this method does not result in a led pattern to indicate that it is in bootloader mode. Once you have run through the procedure with the old utility you will now be ready to use the new one. |
| Randal Biza 17.01.2012 | Have you checked out this thread? http://www.djranking s.com/community /showthread.php?t=16533 |
| Eveline Hazen 13.01.2012 | Same thing happened to me is there anyone that could possibly lead us in the right direction? |
| Valarie Rossen 26.12.2011 | Just tried the procedure of the button on the board described in the PDF but without success. I haven't the buttons so I connected with a little bit of solder wire, but nothing happened, still all leds on |
<< Back to MIDIfighter Resources and DiscussionReply