Kontrol S4 issue with Live PA

Home :: NI - Native Instruments S4/S2 Controller talk :: Kontrol S4 issue with Live PAReply
Kontrol S4 issue with Live PA
Posted on: 01.04.2011 by Camille Darlington
Hi guys.

Having an issue where if I try to do scratching on the jogwheels, the speakers have some distortion or noise. I tried jogwheeling on a channel that wasn't on air, even with filter at 100%, it seemed to 'lag' or slow down the playing channels audio + continue to distort. I'm running a laptop to the S4, as well as a X1. I'm using the TRS outputs to a pair of RCF 310A's with XLR cables.

Any assistance would be great as my scratching last evening was embarassing! :P

Btw I'm running the current Traktor Pro S4, was hoping to rectify this problem before upgrading to T2.
Camille Darlington
01.04.2011
Hi guys.

Having an issue where if I try to do scratching on the jogwheels, the speakers have some distortion or noise. I tried jogwheeling on a channel that wasn't on air, even with filter at 100%, it seemed to 'lag' or slow down the playing channels audio + continue to distort. I'm running a laptop to the S4, as well as a X1. I'm using the TRS outputs to a pair of RCF 310A's with XLR cables.

Any assistance would be great as my scratching last evening was embarassing! :P

Btw I'm running the current Traktor Pro S4, was hoping to rectify this problem before upgrading to T2.
Leeanna Ayla
02.04.2011
there's a software volume and hardware volume so it's a little tricky to get dialed in and my not show up as red on the controller. I run my software volume around -5 or so most of the time. Is auto gain on? What about the limiter? Some have attributed funky sound to the limiter.
Camille Darlington
02.04.2011
Alright...so what should I do apart from the buffer?

My levels were fine all evening , occasionally too much bass led to entering the red zone in the channel but never in the over master output.
Addie Engbrecht
02.04.2011
you might be clipping and the master limiter is turned on.....worth a look
Loni Allfrey
02.04.2011
.....way too much, change the buffer size settings, until you get under 10....but i'm not sure it will solve your problem...
Camille Darlington
01.04.2011
Well my S4 currently isn't connected but just opening it (with no audio routed) it says 10.2 (processing) 10.2 (output) = 20.4. Hope that helps?
Leeanna Ayla
01.04.2011
What's your latency set at?

<< Back to NI - Native Instruments S4/S2 Controller talkReply

Copyright 2012-2023
DJRANKINGS.ORG n.g.o.
Chuo-ku, Osaka, Japan

Created by Ajaxel CMS

Terms & Privacy