midi sync S4 to S4 help
midi sync S4 to S4 help Posted on: 08.01.2012 by Merissa Ullmer Hi everyone!Been trying to sync two S4s together and for some reason can't seem to get it working and hoped one of you would have dealt with this issue... in the manual (14.2.2) is says that in the Slave S4 I'm supposed to make a generic midi device: Code:
1. Create a new generic MIDI device in Preferences > Controller Manager. Assign the In-Port to the device you want to use for receiving the incoming MIDI Clock Signal. 2. In the Global section open the Master Clock panel by clicking the Metronome. 3. Choose External mode by clicking the EXT button. In this mode the TRAKTOR Master Clock follows the external MIDI Clock signal once it is started. 4. To sync the clock to the phase of the application or hardware sending the MIDI Clock sig- nal, press the start button on the sending device. 5. In case of an offset between the sending hard- or software and TRAKTOR, the offset has to be adjusted in the sending (Master) device. Is there a subtle nuance to one of the above that cold have thrown me off? Any help is great appreciated! thanks! | |
| Merissa Ullmer 08.01.2012 | Hi everyone! Been trying to sync two S4s together and for some reason can't seem to get it working and hoped one of you would have dealt with this issue... in the manual (14.2.2) is says that in the Slave S4 I'm supposed to make a generic midi device: Code:
1. Create a new generic MIDI device in Preferences > Controller Manager. Assign the In-Port to the device you want to use for receiving the incoming MIDI Clock Signal. 2. In the Global section open the Master Clock panel by clicking the Metronome. 3. Choose External mode by clicking the EXT button. In this mode the TRAKTOR Master Clock follows the external MIDI Clock signal once it is started. 4. To sync the clock to the phase of the application or hardware sending the MIDI Clock sig- nal, press the start button on the sending device. 5. In case of an offset between the sending hard- or software and TRAKTOR, the offset has to be adjusted in the sending (Master) device. Is there a subtle nuance to one of the above that cold have thrown me off? Any help is great appreciated! thanks! |
<< Back to NI - Native Instruments S4/S2 Controller talkReply