Trigger Finger Help
Trigger Finger Help Posted on: 06.04.2013 by Alyse Chiong Downloaded the mapping from the map region of DJTT, Followed the instructions of reseting the trigger finger to factory settings and it is still not recognized by Traktor. Any suggestions would be appreciated! | |
Kellie Myrum 07.04.2013 |
Originally Posted by rkelley23
|
Alyse Chiong 07.04.2013 |
Originally Posted by JJDShrimpton
Appreciate the input though, thanks |
Alyse Chiong 06.04.2013 | Downloaded the mapping from the map region of DJTT, Followed the instructions of reseting the trigger finger to factory settings and it is still not recognized by Traktor. Any suggestions would be appreciated! |
Dannie Dimora 09.04.2013 | Same happened to my triggerfinger. Another factory reset fixed it for me... |
Renata Shehu 07.04.2013 | sometimes if it's a PC the trigger finger will only be recognized by the windowsOS as a "trigger finger" if it's plugged into a USB powered hub first and not directly to the computer...could that be the problem?? also try and figure out what midi channel the triggerfinger mapping you dowloaded transmits on...you can find that info in the midi mapping section of the preferences where it says (command...note...modifiers...channel) it should be right there....then i forgot what buttons to press on the TF to edit the GLOBAL parameters but you slide the control F2 fader up and down to switch between midi channel....make sure its the same as the one your mapping uses |
Kellie Myrum 07.04.2013 |
Originally Posted by rkelley23
|
Alyse Chiong 07.04.2013 |
Originally Posted by JJDShrimpton
Appreciate the input though, thanks |
Charline Gossom 07.04.2013 | What happens when you try to get it to work? In the mapping editor you have to select it as a 'generic midi controller' then set the in/out to the Trigger Finger. I was recently using my Trigger Finger with Traktor but have since sold it, so sorry if this isn't 100% accurate |
<< Back to General DiscussionReply