DJM-2000 to Amp - When I kill the EQs, I can still hear the track playing, how to fix
Home :: General Discussion :: DJM-2000 to Amp - When I kill the EQs, I can still hear the track playing, how to fixReply
DJM-2000 to Amp - When I kill the EQs, I can still hear the track playing, how to fix Posted on: 27.06.2013 by Jorge Furber Hey guys! Sorry, I haven't been really active lately. But I'm back with a question!I'm redoing my whole setup (been doing it for over a month, I know) and I just plugged in my mixer and my amp. Weirdly, when I'm playing with the EQs, and turn the knobs to 0, I can still hear the track playing (something that was not happening with my old setup). Any ideas if that's normal? And how to fix it if it's not? Thanks guys! | |
| Jorge Furber 27.06.2013 | Hey guys! Sorry, I haven't been really active lately. But I'm back with a question! I'm redoing my whole setup (been doing it for over a month, I know) and I just plugged in my mixer and my amp. Weirdly, when I'm playing with the EQs, and turn the knobs to 0, I can still hear the track playing (something that was not happening with my old setup). Any ideas if that's normal? And how to fix it if it's not? Thanks guys! |
| Jorge Furber 28.06.2013 | Thanks guys!! Fixed it! |
| Tesha Freudenstein 28.06.2013 | what they said. at the moment your EQs are set to have -26db as their lowest point. setting the mixer to to "isolator" will provide with a full kill EQs. |
| Alphonso Deitchman 27.06.2013 | The Isolator EQ switch is in the bottom right section of the mixer next to the fader curve settings. |
| Augustine Mitzen 27.06.2013 | do you have the channel EQs set to the isolator mode? |
<< Back to General DiscussionReply