Reply to Vci-100 se & Midi Fighter problem
Vci-100 se & Midi Fighter problem I just upgraded to the most recent version of Traktor, 1.2.7, and after doing so everything stopped working. I am using the VCI-100 SE Firmware 1.3, with the 2.5 mapping. I am also using one midi-fighter. For the midi-fighter I was using the MF 1.1 mapping with the 2.5 mapping on VCI and everything was working fine except I couldn't trigger sampling mode and the dedicated echo effect. I noticed the deckalized version and saw the video showing Ean using those features and deduced that was the reason I couldn't use sampler/echo features. Naturally I downloaded and that is where everything went crazy. Sampling mode and echo now worked but I couldn't focus on the deck I wanted like in MF 1.1. Every time I would switch decks it would stop playing the track in the deck it went out of and disable the track from the deck I went into (unable to hit play until I cycle through all the decks again). I believe midi data is getting confused somewhere and am at a loss. I have tried every combination of things, went in and selected the in and out ports to be midi-fighter and it still didn't work. I noticed there are four deck settings to select from in preferences after importing deckalized mode. Do I need to adjust all of them, one of them, do I need MF 1.1 imported also so I can switch decks? On the video Ean had two midifighters, but read in the description that deckalized can still work with one midi fighter to control all four decks. Trying to figure out what setup is needed to have vci-100 se & fully functioning midi fighter (sampling/echo) coexisting with each other. You guys are amazing and am sure its my stupidity stopping everything from working. This seems like something others might run into and hope this can be of use to them as well. Cheers! | |
You need to login in order to write on our forum |
<< Cancel