Reply to LED Hardware Mod - Adding two LEDs

Hey guys,

I was wanting to add two leds to my MidiFighter one above and one below the PCB.

Having not done electronics for some time I was wondering if it would work. I'd be putting the leds in parallel so same voltage but half the current. Should I drop the resistor size in half to keep the current the same for each led ?

The other believe that I noted in the video was Ean's comment that the section that you short out was "space for a resistor" so should I just put the 220 ohm there instead and no resistor on either of the leds ?

I take it that I can't find the circuit diagram anywhere as that's your hard efforts ? I just have a friend who's an electrical engineer who would help me if they could see it.

The video is here and he mentions the bit about the shorting section around 3m 20secs in:
http://www.youtube.com/watch?v=6VOWZWFUvMs