Reply to Custom Midifighter Problem

2011-07-09-16-04-34-841.jpg


Whenever I try mapping my knobs and faders, some of them are sharing the same assignment numbers.

Each knob and fader offers 4 mapping points. There's 0, 1-50, 51-99, and 100. But when I set a knob in the 51-99 range it will glitch between two assignments. For instance my top left knob assignments are as follows. 0 = Ch03.Note.G#7 1-50= Ch03.CC.018 51-99= glitches between Ch03.CC.019 and "Ch03.CC.019 + Ch03.CC.018" 100= Ch03.Note.A7

So here's where things get even weirder. My far left knob and fader share the assignment number Ch03.CC.018. So if I set an effect value to that assignment, both will control the same thing. My two knobs also share Ch03.CC.019. And my two faders share Ch03.CC.017. I can't figure out a way around this issue. I've tried re-flashing the firmware. Everything is up to date. Is this a coding defect? Any help would be much appreciated.