MF3D with VCI-400 and traktor problem

Home :: MIDIfighter Resources and Discussion :: MF3D with VCI-400 and traktor problemReply
MF3D with VCI-400 and traktor problem
Posted on: 05.05.2012 by Garrett Blachford
Hi, I am trying to use the VCI-400 with the MF3D in traktor pro. I have followed the Ean instruction video on importing the tsi files. Problem is, that I can't seem to figure how to be able to use both controllers at once.

If i set In-port and out-port on the controller manager options to MF3D (like Ean says in the video) I can't use the VCI-400 at all. What am I doing wrong? I followed Ean's exact video instructions.
Garrett Blachford
05.05.2012
Hi, I am trying to use the VCI-400 with the MF3D in traktor pro. I have followed the Ean instruction video on importing the tsi files. Problem is, that I can't seem to figure how to be able to use both controllers at once.

If i set In-port and out-port on the controller manager options to MF3D (like Ean says in the video) I can't use the VCI-400 at all. What am I doing wrong? I followed Ean's exact video instructions.
Garrett Blachford
06.05.2012
Thanks Padi.
Nedra Fresneda
05.05.2012
First import the MF3D like you have been doing and check the I/O ports are set accordingly, then reimport the VCI mapping and again check the I/O ports. The 2 mappings are independent.

<< Back to MIDIfighter Resources and DiscussionReply

Copyright 2012-2023
DJRANKINGS.ORG n.g.o.
Chuo-ku, Osaka, Japan

Created by Ajaxel CMS

Terms & Privacy