Updating MidiFighter 3D Firmware - Solution to update failed status
Home :: MIDIfighter Resources and Discussion :: Updating MidiFighter 3D Firmware - Solution to update failed statusReply
Updating MidiFighter 3D Firmware - Solution to update failed status Posted on: 15.02.2013 by Cleotilde Dodsworth This video walks you through updating your MidiFighter 3D's firmware to the latest one so that you can take full advantage of the controller. Hope you find it useful. | |
| Cleotilde Dodsworth 15.02.2013 | This video walks you through updating your MidiFighter 3D's firmware to the latest one so that you can take full advantage of the controller. Hope you find it useful. |
| Cleotilde Dodsworth 16.02.2013 | Just to explain what is happening here, I decided to write a short description about it : This is a way to set your midi fighter 3d in bootloader mode and update the firmware in windows. The issue arises when the midifighter utility tries to put midifighter control in bootloader mode, it disconnect and connects it back but windows can't load the booloader driver, therefore midifighter waits until it timesout and gives up. By holding down the four corner buttons during the process, we prepare midifighter control to get into bootloader mode the moment windows remount it. If this doesn't work then you might need to reinstall the utility and retry. |
| Latoria Kavulich 16.02.2013 | Thanks for this. |
<< Back to MIDIfighter Resources and DiscussionReply