Traktor FX Cpu Lag!?!?!?

Home :: General Discussion :: Traktor FX Cpu Lag!?!?!?Reply
Traktor FX Cpu Lag!?!?!?
Posted on: 20.08.2012 by Verdell Mulroney
Very often when I either engage fx 1-4 on the mixer OR select between effects my computer freezes. I use a 13' macbook pro and I'm usually just running traktor playing 2 maybe 3 decks.

Its not the midi gear I don't believe because it only happens on these two commands. Changing effects and assigning effects to decks.


I really don't want to have the song skip a beat everytime i want to use my effects! Whats going on here?
Verdell Mulroney
21.08.2012
Originally Posted by photojojo
What's your latency set at? Does it only happen the initial time you engage an effect or assign an FX section to a deck and then afterwards it's fine? Try to assign all the FX banks at the very beginning before you start playing and see if it happens again in the same set.
it might be the latency.. Do I just this under the main "Audio setup" page under preferences where it says latency?? Whats a good setting?



Also as far as assigning all the fx at the beginning. Would I just have to do tht once and then I could turn them off? Cause i don't want to have to keep them on
Verdell Mulroney
20.08.2012		Very often when I either engage fx 1-4 on the mixer OR select between effects my computer freezes. I use a 13' macbook pro and I'm usually just running traktor playing 2 maybe 3 decks.

Its not the midi gear I don't believe because it only happens on these two commands. Changing effects and assigning effects to decks.


I really don't want to have the song skip a beat everytime i want to use my effects! Whats going on here?
Verdell Mulroney
21.08.2012
Originally Posted by photojojo
What's your latency set at? Does it only happen the initial time you engage an effect or assign an FX section to a deck and then afterwards it's fine? Try to assign all the FX banks at the very beginning before you start playing and see if it happens again in the same set.
it might be the latency.. Do I just this under the main "Audio setup" page under preferences where it says latency?? Whats a good setting?



Also as far as assigning all the fx at the beginning. Would I just have to do tht once and then I could turn them off? Cause i don't want to have to keep them on
Leeanna Ayla
21.08.2012		What's your latency set at? Does it only happen the initial time you engage an effect or assign an FX section to a deck and then afterwards it's fine? Try to assign all the FX banks at the very beginning before you start playing and see if it happens again in the same set.
Melinda Wubben
21.08.2012		I believe by 'typical' tokenasianguy means that it's something caused by too tight audio latency settings. It's definitely not typical as in something that should happen. Try increasing your audio buffer size in prefs and see if it makes a difference.
Darlene Strohbeck
21.08.2012		Are you using an internal or external mixer?

If you're using internal then it sounds like typical latency issues.
Verdell Mulroney
21.08.2012		seriously.. no replies?

<< Back to General DiscussionReply

Copyright 2012-2023
DJRANKINGS.ORG n.g.o.
Chuo-ku, Osaka, Japan

Created by Ajaxel CMS

Terms & Privacy