Maschine 2 serial number
Maschine 2 serial number Posted on: 15.11.2013 by Zofia Felten Hi all,I just upgraded from a Mikro to a Maschine Mk2. I have downloaded all the necessary but need a serial number for Maschine 2 to work, but I have nothing among my documentation. I am waiting for NI support to get back to me, but wondering if anyone has any thoughts or a similar experience. It is a bit annoying to buy one, and have it sitting there for a few days unused. Cheers | |
| nayit ruiz jaramillo 15.11.2013 |
Originally Posted by 6ft Stereo
There's no need to contact support for serial numbers. |
| Zofia Felten 15.11.2013 | Hi all, I just upgraded from a Mikro to a Maschine Mk2. I have downloaded all the necessary but need a serial number for Maschine 2 to work, but I have nothing among my documentation. I am waiting for NI support to get back to me, but wondering if anyone has any thoughts or a similar experience. It is a bit annoying to buy one, and have it sitting there for a few days unused. Cheers |
| Gaynell Rydberg 19.11.2013 | You can edit and change the serial number in the service center. |
| Zofia Felten 19.11.2013 | I have the serial for the original Maschine software, but because I already have an original Mikro, Service Centre believes that it is already activated. So I can't activate the software which will then prompt NI to send me the serial for Maschine 2. I am in conversation with them, but it is getting annoying. |
| Augustina Zulu 19.11.2013 | You should have gotten a serial on the disk that comes with the Maschine. Where did you buy it? |
| Tisha Muckle 18.11.2013 | Did you buy the MK2 2nd hand with no software? |
| Zofia Felten 18.11.2013 | The problem is that I have downloaded the maschine 2 software, along with Komplete Selection etc... but can't activate them because I have no serial numbers for the software, even though I am supposed to get Maschine 2 for free with the new MK 2 controller. Any ideas, their help hasn't been that helpful so far... |
| nayit ruiz jaramillo 15.11.2013 |
Originally Posted by 6ft Stereo
There's no need to contact support for serial numbers. |
| Ardith Leabo 15.11.2013 | The Maschine software for your Micro should work for the Maschine MKII. When I had both units, I inter-changed both without any issues. Why do you need the serial again if you already installed it for your Mikro? |
<< Back to General DiscussionReply