Reply to Dj Booth Build DIY cool booth for less than 150$

I am not able to purchase Ikea stuff in Montana but I really wanted a taller dj booth. I decided to make my own as leaning over a folding table kills your back. Not being able to spend more than 150$ and needing to meet certain size requirements i was able to cheaply design my ideal dj booth.
I tested some hieghts and found 33" tall x 48" long x 24" deep to be ideal for a 12" mixer with either two cdj's or two 1210's. Using exactly two sheets of ply wood for everything you are able to dramatically save on cost. Make sure the hardware store does all the long cuts for you, its usually free, and a lot easier to haul smaller pieces in your car. All the leg curves were drawn and copied from one leg to the rest. the round corners were drawn with a medium coffee can. Remember to leave holes for cable to pass through the back and sides. L-brackets were used to tie the whole thing together becuase they leave a more furniture like finish and no exposed screw heads.

Tools needed: drill, jig-saw (if you want the curves, sand paper, speed square, strait edge of some kind (level)

Supplies: L-brackets (comes with screws), sandpaper, pencil, 2 sheet of 8' x 4' ply 3/4" (Birch in photo)

Difficulty: 6/10

time: 6 hours