Reply to Help Needed with Denon MC3000 controller and Windows XP Sp3.....

Ok as the title suggest I'm having problems and can't get my head around the problem and I was hoping that one of you guys could help me out before I loose all my hair...lol

Yesterday I recieved my new MC3000 controller and was really excited to get it up and running as my old controller died at the weekend.

So I installed the latest Denon Asio Driver 2.2.2 and also Updated the firmware to the latest version V1005. I have Traktor 2.6 Installed on my PC so I never Installed the enclosed LE software. I set up my audio routing etc and followed the wizard instructions for importing the Tsi, as far as I know thats all I need to do.

So heres my problem, when I switch on the controller it does it's light blinking as normal at startup but that's all it does, None of the controls of the 3000 are moving anything in the software, there appears to be no midi signal being sent The CTRL panel on top of Traktor is not illuminating as it should to show midi command being sent to software. I have tried with every Tsi there is for the 3000 believeing maybe it was a bad Tsi but I get the same from everyone of them. Now I know XP is old but it's what I have at the moment and Denon say it can run on my system XP with SP3, I really hope one of you guys can help me out as I'm not getting much info from other community s (Native Instruments & Denon),

I can control Traktor with the keyboard so it's a controller problem i recon not software.

I really hope someone can help me, If not I need to send the unit back to Germany and thats a pain