Reply to Traktor Mapping Tips

Traktor Mapping Tips
I couldn't find a thread about Traktor mappings and tips n such, so I figured I'd start one off with a question.

For a mapping I've been working on, I have a few variables that I'm using to determine what "mode" a controller is in. There are 9 buttons, here's a breakdown:

Function - Holding down changes variable 1 to 1, otherwise v1 = 0.
Mode 1 - While v1 = 1, sets v2 to 1. v2 will stay set until changed by another button.
Mode 2 - While v1 = 1, sets v2 to 2.
Mode 3 and 4 should be obvious.

Now, buttons 5-8 are sub-function buttons, so that while in Mode 1 and holding Function I can make each button have additional capabilities. Again, for example:

v2 is set to 1, holding down Function sets v3 to 1, but only while being held down.
If v1 = 1 (Function is held down) and v2 = 2 (controller is in Mode 2), then v3 = 2. But only while Function is being held down, like for v1.

If you haven't noticed, I have a programming background. Anyway, here's the problem. That all works perfect, except v3 tends to kind of lock up. If I change to Mode 4, v3 = last setting. Then if I tap Function it all works fine. Any suggestions? Sorry if my terminology or sentence structure is a bit confusing, I can try to rewrite it if you want me to.

And as a final note, I'm by no means a master of Traktor, but I can try to give any help or tips if anyone else has questions over anything.
You need to login in order to write on our forum

<< Cancel

Copyright 2012-2023
DJRANKINGS.ORG n.g.o.
Chuo-ku, Osaka, Japan

Created by Ajaxel CMS

Terms & Privacy