Reply to Ddj-sx bug fix
Ddj-sx bug fix Hello, assuming your having the same issue I'm just going to quickly jump right into this. Recently landed a new club residency so ordered the shiny new DDJ-SX which has worked incredibly up until a practice sesh last evening
. Specifically when I'd hit a cue points too hard it would cue the wrong cue point! (Being that they are velocity sensitive: they should be able to take a hit) Again, Using it to gig every week this was a major issue...Altho, before sending it in (thankfully I ordered from DJTT partially considering their amazing rep in quality service encase anything like this did ever happened!) time being of the essence I first scoured the net for any DYI fix: & Wala! I found that downloading the most recent firmware update from http://pioneerdj.com/support/product...p=DDJ-SX&t=179 (current version being 1.07, mine was shipped with 1.05) & following this firmware upgrade guide:
(which for those of you who can't watch that video explains that Before installing the downloaded firmware from Pioneersdj.com you must First hold the DDJSXs' Shift+Sync while powering up the unit to start it in Firmware-Update-Mode then run/install the firmware & restart the DDJSX normally) BOOM! Completely fixed my issue! & Hopefully any of yours, Rock on fellas! *ADDITIONAL PROBLEM FIX! I has having an issue with my left Jog wheel in vinyl mode (specifically the touch sesnsitivity was so low I'd have to use my hole palm & push very hard to stop the track (even with the sesvitivity knob turned all the way up!) after more e-research I ran across these recommendations via Pioneer community moderators: first they explained how the platter technology is similar to that of the iPad (which involves static) so when moving the unit from room to room with more static you need to re-adjust the sensitivity knobs. So basically add to your gear set-up routine turning the sensitivity knobs all-the-way-down, all-the-way-up, then while playing with the platter adjusting it to the perfect spot (mine usually being around 12 o-clock) Additionally* They mentioned the USB cord used has an effect on it (I don't recall the science behind that but have ordered a DDTT one as well as 2 other high-end ones to test & will share my results soon.) Any other advice on this would be greatly appreciated so feel free to comment blow! -S AKA LIVEFAST | |
You need to login in order to write on our forum |
<< Cancel